Responding 24 hours a day

Central Texas time

It is late. Here is what to do.

We respond 24 hours a day. Send your request and a team member will call you back within 90 minutes.

If anyone is in danger, or there is fire, smoke, or a gas smell, leave and call 911 first.

  1. 1

    Shut off the water.

    Close the main valve, usually near the street, in the garage, or where the line enters the house. If the leak is from one fixture, close its valve.

  2. 2

    Make the wet rooms safe.

    Turn off power to wet rooms at the breaker, but only if you can reach it without standing in water. Move people and pets out of those rooms.

  3. 3

    Record it, then send the form.

    Take a slow video of every wet room before you move anything. Then send the short form on this page and a team member will call you back within 90 minutes.

Flagship service

Water damage mitigation and restoration

Burst pipes, failed supply lines, water heaters, appliance leaks, slab leaks, and storm water. We stop the spread, dry the structure with our own equipment, and document every reading.

What happens when you contact us about water damage

When you reach 111 about water damage, a team member talks you through stopping the water and staying safe, then comes out to assess the damage in person. Mitigation begins once you approve the scope: extraction, removal of materials that cannot be dried or restored, and structural drying with readings logged on each visit.

Water moves further than it looks. It wicks up drywall, runs under cabinets and baseboards, and settles beneath wood floors. A moisture map at the start shows where it actually went, and the same points are checked on every return visit.

Common sources we respond to

  • Burst or frozen pipes, including after a hard freeze
  • Failed supply lines at sinks, toilets, ice makers, and washers
  • Water heater and appliance failures
  • Leaks under a slab foundation
  • Roof leaks and wind-driven rain after storms
  • Outside flood water entering the home

Mitigation scope

  • Source control and safety check
  • Water extraction from floors and rugs
  • Moisture mapping and photo documentation
  • Removal of materials that cannot be dried or restored
  • Structural drying with our own dehumidifiers and air movers
  • Return visits with logged readings
  • Contents moved, protected, or packed out
  • Closeout file with drying records

Fine homes

Materials that need a careful hand

Many Central Texas homes include finishes that do not respond well to aggressive demolition. We look for ways to dry in place where it is reasonable, and we say so plainly when it is not.

Wood floors

Site-finished and engineered floors are read across the whole room before any decision about drying in place or removal.

Plaster, stone, and millwork

Plaster walls, limestone, and built-in cabinetry hold water differently from drywall and are dried and checked on their own terms.

Rugs, art, and collections

Valuable items are moved out of harm first and, where needed, packed out to climate-controlled storage.

Water categories

Clean, gray, and contaminated water are handled differently

The source of the water shapes the plan. Clean water from a supply line can often be dried in place if work starts quickly. Water that sits, or runs through walls, floors, and insulation, picks up contamination and is then handled as gray or contaminated water. Water from a dishwasher or washing machine carries more contamination. Sewage backups and outside flood water are treated as contaminated: porous materials they touched, such as carpet, pad, drywall, and insulation, are usually removed and discarded, while hard, non-porous surfaces can often be cleaned and kept. Protective equipment is used throughout.

An honest note on flood water. According to FEMA's FloodSmart program, most homeowners and renters insurance does not cover flood damage. If outside water came into the home, ask your agent whether you have a separate flood policy.

Read our guide to water damage and insurance

FAQ

Water damage questions

What is water damage mitigation?

Water damage mitigation is the work that stops the damage from getting worse: stopping the source, extracting water, removing materials that cannot be dried or restored, and drying the structure with dehumidifiers and air movers while readings are recorded. Restoration and repairs come after the structure is dry.

How long does it take to dry a home after water damage?

It depends on how much water there was, how long it sat, and which materials got wet. Drywall, wood floors, plaster, and stone all dry differently. We take readings on each visit and do not remove equipment until the materials reach their drying goals, which are based on readings from dry, unaffected areas of the same materials. We tell you plainly how it is going.

Can wood floors be saved after a leak?

Often they can, if drying starts quickly and the boards have not cupped or separated past recovery. We take readings across the floor and tell you honestly whether drying in place is reasonable or whether boards should come up.

Is flood water from a river or creek handled differently from a pipe leak?

Yes. Outside flood water can carry soil, sewage, and chemicals, so affected porous materials are usually removed rather than dried, and protective equipment is used. Coverage is also different: most homeowners policies do not cover flood damage, which is usually a separate flood policy.

Will my insurance cover the water damage?

Only your insurance company can answer that under your policy. The Texas Department of Insurance says most homeowner policies cover sudden and accidental water damage, such as a burst pipe, but usually not damage from gradual leaks. We document the damage so your adjuster can review it.

Open a file

Water or fire damage? Talk to a team member.

We respond 24 hours a day. Send the short form and a team member will call you back within 90 minutes. We come out, look at the damage, and give you an honest assessment. There is no pressure to sign anything on the first visit.

What goes in your file

  • 01An honest assessment. A team member looks at the damage in person and tells you plainly what we see and what we recommend.
  • 02A written scope before work starts. You know what we plan to do and why, and you can share it with your insurance company.
  • 03Photo and video documentation. Every affected area is recorded before, during, and after the work.
  • 04Moisture readings and drying records. Logged on each visit until materials reach their drying goals.
  • 05A room-by-room contents inventory. When contents are packed out, each item is listed, photographed, and tracked.
  • 06A closeout file. Photos, readings, inventory, scope, and the signed completion record in one place.

See our process

Intake sheetForm 111-A

Request a call back

Tell us where and what happened. Required fields are marked.

Send the form and a team member will call you back within 90 minutes. We use your details only to respond to this request. See our privacy notice.

Request a call back